![]() ![]() The installer will search for the printer on the network. When the Connection method window appears, select Use the printer with wireless LAN connection.If you select No, the drivers will not be installed. When the driver installer begins, select Next.If you receive a prompt asking for permission to run the file after you double-click it, select Yes or Continue, depending on what browser you're using. After you download the MP Drivers, double-click the file to open it.If you wish to install it, you must have the MP Drivers installed first. If you're prompted to Run or Save the file, save it to your computer. Select the Select button to the right of the MP Drivers. In the Drivers section of Drivers & Downloads, download and install the MX920 Series MP Driver ( this includes the Canon IJ Scan Utility).If the website doesn't detect which version is installed on your computer, you can select it from the Operating System drop down menu. The version of Windows installed on your computer will be automatically detected. Select here to go to the PIXMA MX922 support page.After it re-initializes, try to connect the printer to the network again.Īfter your printer connects to the network, download and install the drivers and software. If the password is correct, try unplugging the router for 15 seconds. Press OK and verify that the password you have entered is correct. If the printer fails to connect to the wireless network: When the printer connects to the network, press OK.The printer will attempt to connect to the network.If no corrections are needed, press the left Function key (under End setup). ![]() If you need to make any corrections to the password, press OK and you'll be able to make any corrections needed. You'll see the password you entered on the screen. You'll return to the Enter passphrase screen. After you enter the password, press the left Function button (under Done).Refer to Understand entering numbers, letters, and symbols for more information. character) to delete the incorrect characters. If you make a mistake entering the password, you can press the right Function button (below Del. Pressing the middle Function button a second time will change over to numbers and symbols. ![]() Pressing the middle Function button (below Aa1) switches the character set to upper case letters. If you need to switch to upper case letters or numbers and symbols, press the middle Function button below the screen.
0 Comments
Leave a Reply. |